Skip to main content

Mesh Traffic: route running drill for flag football

Mesh Traffic is a flag football drill that teaches route running on crossing routes to players ages 10 and up. It takes 3 players, 2 receivers and a thrower, with 1 cone and 1 football. The receivers cross shoulder to shoulder at a cone 4 yards over the ball, at full speed and never touching.

Keep score and stats for your team with Flag50 Coach, then send parents one link to follow live. Launching spring 2027. Get early access.

By Jay Fraser. Published . Updated .

Mesh Traffic at a glance

Ages
Ages 10 and up
Players
3 at a time: 2 receivers and a thrower
Time
8 minutes
Equipment
1 cone, 1 football
Skill
Route Running
Difficulty
Intermediate

How to run Mesh Traffic

Two receivers run shallow crossing routes from opposite sides and pass shoulder to shoulder at a cone 4 yards over the ball, at full speed and without touching.

Mesh Traffic 3D walkthrough, opening frame: one receiver on each side running shallow crossing routes that pass at a cone 4 yards over the ball, thrower behind the ball

Motion data: CMU Graphics Lab Motion Capture Database (mocap.cs.cmu.edu)

  1. Line up one receiver on each side, about 7 yards from the ball, and set a cone 4 yards upfield over the ball. The thrower stands behind the ball.
  2. Before the rep, the two receivers decide who crosses over the top and who goes underneath.
  3. Both run shallow crossing routes at full speed and pass shoulder to shoulder at the cone, without touching.
  4. The thrower throws to one receiver after the cross. Swap the over and under jobs every rep.

Safety: Contact is a penalty and a collision risk. Receivers pass close but never touch each other or a defender. Start at half speed until the over and under jobs are automatic.

5 10 15 20 25 30 35 40 LOS QB R R
Mesh Traffic setup: one receiver on each side running shallow crossing routes that pass at a cone 4 yards over the ball, thrower behind the ball

Coaching cue

Decide who goes over and who goes under before the rep.
  • Decide over and under before the rep, every rep.
  • Keep full speed through the cross. Slowing down or swerving wide breaks the timing.
  • Pass close, never touch. Each receiver runs the route, never at a defender.

Common mistakes

  • Slowing down at the cone and bumping the teammate.
  • Swerving wide around the cone, which spreads the crossing routes apart.
  • Looking for the ball before the cross and losing track of the teammate.

Make it easier or harder

Make it easier: Walk the crossing routes first, then jog, so both receivers learn the over and under spots.

Make it harder: Add a defender who covers one receiver, and the receivers still pass close without touching anyone.

For your players

Read these three lines to your players before the first rep.

  1. Decide with your teammate: who is over, who is under.
  2. Run across and pass close to each other.
  3. Keep running and look for the ball.

Where it shows up in a game

Mesh and shallow cross plays, where two crossing routes create traffic in the middle and one receiver comes open on the far side.

Flag50 Coach

Keep score and stats for your team with Flag50 Coach, then send parents one link to follow live.

Get early access. Leave your email and we'll email you the moment your spot opens up.

Frequently asked questions

Who goes over and who goes under in Mesh Traffic?

Choose a rule and keep it, such as the receiver from the right side always goes over. What matters is that both receivers know before the rep, so neither slows down at the cone. Switch sides each rep so every player learns both jobs.

How close should the receivers pass each other in Mesh Traffic?

Shoulder to shoulder at the cone, close but never touching. Tight crossing routes keep the timing the same every rep, so the thrower knows where each receiver will be. Start at half speed until the pair crosses cleanly.

What if my receivers keep colliding at the cone?

Slow the rep to a walk and check the over and under call before every rep. Most collisions come from both receivers running at the same depth. Have the over receiver pass just above the cone and the under receiver just below it.

Sources

About the author

Jay Fraser

Founder, Flag50

Founder of Flag50, based in Carlsbad, California.